Home > Microphones & Wireless Microphone Systems > Wireless Microphones, Systems & Accessories > Headset / Lapel Wireless Systems

JTS IN164/CM804iF/B Discreet Headset Wireless System with Lapel Mic. Black or Beige Headset

Condition: New
£299.00
More Information
JTS IN164 / CM804i / CM501 Headset and Lapel Wireless Microphone System.
Great sounding wireless headset or lapel wireless microphone system.
Please Note: This is a single channel system supplied with both headset (CM804i) and lapel (CM501) microphones. Either microphone may be used but NOT simultaneously.

This wireless system features contains everything you need for wire free speech applications for education, business, comedy and worship sound. Two great sounding microphone choices are included and JTS' REMOSET system makes setting up and using completely effortless.

This system is supplied with the CM804i headset microphone which is a big step up from standard headsets usually supplied with wireless systems. It is lightweight, comfortable, and produces a great sound with minimal EQ. It is also thin and discreet, and available in beige or black for minimal visibility when in use which also makes it great for theatre-type applications. You can use our product variant menus to select black or beige headset.
It is also supplied with the CM501 lapel microphone for those who would rather use a tie-clip lavalier type microphone. This microphone is also a step up from most standard lapel type mics delivering a detailed yet warm sound with minimal EQ and/or processing.

Using JTS' REMOSET system, all parameters can be set on the IN164 receiver then sent to the the IN264TB transmitter via infra-red link in a fraction of a second, so frequencies can be instantly matched with minimal fuss. 

The LCD screen on the IN164R receiver clearly shows frequency/channel selection, battery level, antenna status and RF and AF levels. A backlight means it can be read in darkness.

The IN264TB beltpack transmitter can run for approx' 12 hours on two good quality alkaline AA batteries.
  
Downloads:
JTS Wireless Microphones Brochure.pdf

Please note: This system is supplied with ONE headset microphone. Black and beige headsets are shown for illustrative purposes. 

Specifications:
 
IN164R Receiver:
Frequency Preparation PLL Synthesized Control
Remoset Frequency Radio Frequency : 2.4GHz
Effective distance: 10m
Carrier Frequency Range 36MHz within 502~960 MHz
Sig/Noise Ratio >105dB
T.H.D <0.6%@1KHz
Display Type LCD with Backlight
Display Parameters: Channel, Antenna A/B, Mute Display, RF/AF Level Meter, Low battery, ID Number
Controls/Switches Power On/Off, Frequency Up/Down, Lock-on,
ID Pairing, Remoset
Audio Output Level: -12dB
AF Output Impedance: 600Ω
Squelch: Pilot Tone & Noise Mute
Operation Voltage: 12-18 VDC, 500mA
Output Connectors: 1 XLR Balanced Socket
1 Ø6.3mm unbalanced phone jack
Dimensions(m/m) 210mm(W) * 40mm(H) * 165.5mm(D)

IN264TB Beltpack Transmitter:
Frequency Preparation: PLL Synthesized Control
Carrier Frequency Range: 502~960 MHz
RF Outputs: 10mW / 50mW
(Depend on Local Regulation)
Stability: ±10KHz
Frequency Deviation: ±48KHz
LCD Display Parameters: Channel, Battery Fuel Gauge,
Controls/Switches: ID Number
Power On/Off, AF Level,
Frequency Up/Down, PAD, Gain Control, ID Pairing
Lock-on Mode
Output connector type: 4P mini XLR
Spurious Emissions: <-50 dBC
Audio Frequency Response: 40~18,000 Hz
Battery Requirement: UM3, AA 1.5V*2

CM804iF/B Headset Microphone:
Available Connector Types
 
801C4 (4 pin mini XLR)
801C3 (3 pin mini XLR)
801CS (3.5 stereo plug)
Frequency Response: 60 ~ 15,000Hz
Polar Pickup Pattern: Omni-directional
Sensitivity (1KHz): -64±3 dB* (0.63mV)*0dB=1V/μbar
Impedance: 1.8kΩ
Max. SPL for 1% THD: 130dB

CM501 Lapel/Tie Clip Microphone:
Connector Type: 4P Mini XLR
Frequency Response: 100~15,000 Hz
Polar Pickup Pattern: Cardioid
Sensitivity (1KHz): -60±3 dB* (1mV)*0dB=1V/μbar
Impedance: 2.2kΩ
Max. SPL for 1% THD 130dB 
Dimensions(mm) Ø10.1mm(W)*  26.4mm(H)
Weight: 21.5g
Customer Reviews